The Best In Waterless Car Care Products       

 Free Shipping   on Orders Over $100.00

                  No-Wet Waterless Car Wash

     Instructions for Use                                                                 

• Park your vehicle in a shaded area-avoid applying No-Wet Waterless Car Wash and Wax in direct sunlight. This will keep the product from drying to fast and allow the surfactants to penetrate, lift and emulsify the dirt and grime from the surface.
• Make sure vehicle is absolutely dry and free of any moisture
• Use two 100% Cotton Terry Towels or substitute one towel with one No-Wet Fluffy Terry Microfiber Towel for buffing. When laundering your soiled towels, allow them to soak first, then launder as usual. DO NOT Use bleach, fabric softener as these products will make the towels less absorbent. DO NOT DRY IN A DRYER  DO NOT IRON TOWELS
• Before filling applicator, shake filler bottle approximately 20-30 seconds by holding filler bottle Upside Down and twisting your hand vigorously from left to right. Also follow the same procedure before using filled applicator. It is very important to make sure all ingredients are completely mixed.
• Do Not fill the applicator past the fill line. Fill to about 1/2 inch below fill line to insure a good spray.
• Using the pump cap, press up and down approximately 20 times until a resistance is felt, (cap will rise about 1/2 inch) continue to pump the applicator during applications with one or more pumps after each spray.
• Spray mist over soiled area using a sweeping motion, keeping the applicator about 18-24 inches from surface, covering about 3-4 sq. ft. each time. Let stand for about 5-10 seconds, then wipe with first towel in one direction, (you are now picking up the dirt that is floating in the No-Wet solution) first easy, then a little harder. As hazing appears, use second terry cloth, or the No-Wet Microfiber Buffing Towel and buff in a circular motion to a clean and gleaming finish!
• PLEASE USE COMMON SENSE; IF DIRTY AREA IS CAKED AND PACKED, KNOCK OFF EXCESS BEFORE MICROMISTING
• WHEN USING ON VEHICLE INTERIOR, SPRAY NO-WET ON TOWEL AND PROCEED TO CLEAN-DO NOT SPRAY DIRECTLY ON INTERIOR ITEMS
• When using to clean glass, chrome etc etc. wipe product off right away! When it comes to glass-LESS IS BEST
• If the Micro Mist Applicator seems clogged or doesn't spray properly-even after a thorough shaking-turn the bottle upside-down and depress the spray valve for 5-10 seconds to expel air only. Then pump additional air into the bottle and retry. Repeat this procedure two or three times, if necessary. This also should be done after every time you use the applicator so no wax settles in the applicator tube.
• It is best to store gallons on their side until half empty...to mix gallons turn upside down...hold with two hands and twist hands front to back.

Quick Review of the Directions

• Shake fill bottle vigorously for 20-30 seconds
• Pour into exclusive Micro Mist Applicator to about 1/2 inch below fill line
• Pressurize bottle by pumping cap until resistance is felt (1/2 inch rise in cap)
• Spray a light coat of No-Wet on the surface using a sweeping motion
• Wait 5-10 seconds as the No-Wet emulsifies and lifts the dirt from the surface
• Now use the first towel, gently rubbing in one direction to remove dirt and grime. As filmy haze appears, use the second cloth or the No-Wet Microfiber Towel and buff in circular motion to a clean and gleaming finish!
• When using to clean glass, chrome etc etc. wipe product off right away! When it comes to glass, LESS IS BEST
• Do Not spray directly on interior items, spray on terry towel or No-Wet Microfiber Towel then proceed to clean interior

                                               Waterless Car Wash and Wax         Metal Polish/Scratch Remover      Tire Care      Accessories

                                                   Waterless Clean & Green      Upholstery Care      How to Department      FAQ      Contact Us