Park
your vehicle in a shaded area-avoid applying No-Wet Clean and Green WaterlessCar Wash and Wax in direct sunlight. This will
keep the product from drying to fast and allow the
surfactants to penetrate, lift and emulsify the dirt and
grime from the surface.
Make sure
vehicle is absolutely dry and free of any moisture
Use two
100% Cotton Terry Towels or substitute one towel with
one No-Wet Fluffy Terry Microfiber Towel for buffing.
When laundering your soiled towels, allow them to soak
first, then launder as usual.DO
NOTUsebleach,
fabric softeneras
these products will make the towels lessabsorbent.DO
NOT DRY IN A DRYER DO NOT IRON TOWELS
Before filling applicator,
shake filler bottle approximately 20-30 seconds by
holding filler bottle Upside Down and twisting your hand
vigorously from left to right. Also follow the same
procedure before using filled applicator. It is very
important to make sure all ingredients are completely
mixed.
Do
Notfill
the applicator past the fill line. Fill to about 1/2
inch below fill line to insure a good spray.
Using the pump cap, press
up and down approximately 20 times until aresistance is
felt, (cap
will rise about 1/2 inch)
continue to pump the applicator during applications with
one or more pumps after each spray.
Spray mist over soiled
area using a sweeping motion, keeping the applicator
about 18-24 inches from surface, covering about 3-4 sq.
ft. each time. Let stand for about 5-10 seconds, then
wipe with first towel in one direction, (you are now
picking up the dirt that is floating in the No-Wet
solution) first easy, then a little harder. As hazing
appears, use second terry cloth, or the No-Wet
Microfiber Buffing Towel and buff in a circular motion to a
clean and gleaming finish!
PLEASE
USE COMMON SENSE; IF DIRTY AREA IS CAKED AND PACKED,
KNOCK OFF EXCESS BEFORE MICROMISTING
WHEN
USING ON VEHICLE INTERIOR, SPRAY NO-WET ON TOWEL AND
PROCEED TO CLEAN-DO NOT SPRAY DIRECTLY ON INTERIOR ITEMS
When using to clean glass,
chrome etc etc. wipe product off right away! When it
comes to glass-LESS IS BEST
If the Micro Mist
Applicator seems clogged or doesn't spray properly-even
after a thorough shaking-turn the bottle upside-down and
depress the spray valve for 5-10 seconds to expel air
only. Then pump additional air into the bottle and
retry. Repeat this procedure two or three times, if
necessary. This also should be done after every time you
use the applicator so no wax settles in the applicator
tube.
It is best to store
gallons on their side until half empty...to mix gallons
turn upside down...hold with two hands and twist hands
front to back.
Quick Review of the
Directions
Shake fill bottle
vigorously for 20-30 seconds
Pour into exclusive Micro
Mist Applicator to about 1/2 inch below fill line
Pressurize bottle by
pumping cap until resistance is felt (1/2 inch rise in
cap)
Spray a light coat of
No-Wet on the surface using a sweeping motion
Wait 5-10 seconds as the
No-Wet emulsifies and lifts the dirt from the surface
Now use the first towel,
gently rubbing in one direction to remove dirt and
grime. As filmy haze appears, use the second cloth or
the No-Wet Microfiber Towel and buff in circular motion
to a clean and gleaming finish!
When using to clean glass,
chrome etc etc. wipe product off right away! When it
comes to glass, LESS IS BEST
Do Not spray directly on
interior items, spray on terry towel or No-Wet
Microfiber Towel then proceed to clean interior
